flanger — A user controlled flanger.


A user controlled flanger.


ares flanger asig, adel, kfeedback [, imaxd]


imaxd(optional) -- maximum delay in seconds (needed for inital memory allocation)


asig -- input signal

adel -- delay in seconds

kfeedback -- feedback amount (in normal tasks this should not exceed 1, even if bigger values are allowed)

This unit is useful for generating choruses and flangers. The delay must be varied at a-rate, for example by connecting adel to an oscillator output. The feedback can vary at k-rate. This opcode is implemented to allow kr different than sr (else delay could not be lower than ksmps) enhancing realtime performance. This unit is very similar to wguide1, the only difference is flanger does not have the lowpass filter or the requirement that the delay be varied at a-rate.


Here is an example of the flanger opcode. It uses the file flanger.csd.

Example 276. Example of the flanger opcode.

See the sections Real-time Audio and Command Line Flags for more information on using command line flags.

; Select audio/midi flags here according to platform
-odac     ;;;realtime audio out
;-iadc    ;;;uncomment -iadc if realtime audio input is needed too
; For Non-realtime ouput leave only the line below:
;-o flanger.wav -W ;;; for file output any platform

sr = 44100
ksmps = 32
nchnls = 2
0dbfs = 1

instr 1

kfeedback = p4
asnd vco2 .2, 50
adel linseg 0, p3*.5, 0.02, p3*.5, 0	;max delay time =20ms	
aflg flanger asnd, adel, kfeedback
asig clip aflg, 1, 1
     outs asig+asnd, asig+asnd		;mix flanger with original


i 1 0 10 .2
i 1 11 10 .8	;lot of feedback

See Also

More information on flanging on Wikipedia: http://en.wikipedia.org/wiki/Flanger


Author: Gabriel Maldonado

New in Csound version 3.49