ftsamplebank — Reads a directory for sound files.


Reads a directory for sound files and loads them to a series of GEN01 function tables.


iNumberOfFile ftsamplebank SDirectory, iFirstTableNumber, iTrigger, iSkipTime, iFormat, iChannel,
kNumberOfFile ftsamplebank SDirectory, kFirstTableNumber, kTrigger, kSkipTime, kFormat, kChannel,


SDirectory -- a string that identifies the directory to browse for files

FirstTableNumber -- this sets the number of the first table into which a soundfile will be loaded

Trigger -- updates the tables when kTrigger is 1

SkipTime -- begin reading at skiptime seconds into the file.

Format -- specifies the audio data-file format:

1 - 8-bit signed character    4 - 16-bit short integers 
2 - 8-bit A-law bytes         5 - 32-bit long integers 
3 - 8-bit U-law bytes         6 - 32-bit floats

Channel -- channel number to read in. 0 denotes read all channels.

If format = 0 the sample format is taken from the soundfile header, or by default from the CSound -o command-line flag.


iNumberOfFile -- the number of tables that have been created

kNumberOfFile -- the number of tables that have been created

[Note] Note

Loading a lot of sound files into function tables at k-rate may cause some audio dropouts.


This example shows ftsamplebank browsing for samples in a fixed location. It loads all samples it finds into GEN01 function tables and then playsa them back in a sequence, one every second. It uses the file ftsamplebank.csd.

Example 355. Example of the ftsamplebank opcode.

; Select audio/midi flags here according to platform
-odac;;RT audio out
;-iadc    ;;;uncomment -iadc if RT audio input is needed too
; For Non-realtime ouput leave only the line below:
; -o diskin.wav -W ;;; for file output any platform
0dbfs = 1

;load all samples in a given directory into function tables and play them using instrument 1000
instr 1
   iFirstTableNumber = 60;
   iFileCount init 0
   iTrig = 1
   iNumberOfFiles ftsamplebank "./examples/", iFirstTableNumber, iTrig, 0, 4, 1

   until iFileCount>=iNumberOfFiles do
	event_i "i", 1000, iFileCount, 1, iFirstTableNumber+iFileCount
	iFileCount = iFileCount+1


instr 1000
   iTable = p4
   aOut loscil3 1, 1, iTable, 1, 0;
   outs aOut, aOut

i1 0 100


Author: Rory Walsh